D7net
Home
Console
Upload
information
Create File
Create Folder
About
Tools
:
/
usr
/
src
/
linux-headers-6.8.0-88
/
include
/
linux
/
platform_data
/
Filename :
i2c-gpio.h
back
Copy
/* SPDX-License-Identifier: GPL-2.0-only */ /* * i2c-gpio interface to platform code * * Copyright (C) 2007 Atmel Corporation */ #ifndef _LINUX_I2C_GPIO_H #define _LINUX_I2C_GPIO_H /** * struct i2c_gpio_platform_data - Platform-dependent data for i2c-gpio * @udelay: signal toggle delay. SCL frequency is (500 / udelay) kHz * @timeout: clock stretching timeout in jiffies. If the slave keeps * SCL low for longer than this, the transfer will time out. * @sda_is_open_drain: SDA is configured as open drain, i.e. the pin * isn't actively driven high when setting the output value high. * gpio_get_value() must return the actual pin state even if the * pin is configured as an output. * @sda_is_output_only: SDA output drivers can't be turned off. * This is for clients that can only read SDA/SCL. * @sda_has_no_pullup: SDA is used in a non-compliant way and has no pull-up. * Therefore disable open-drain. * @scl_is_open_drain: SCL is set up as open drain. Same requirements * as for sda_is_open_drain apply. * @scl_is_output_only: SCL output drivers cannot be turned off. * @scl_has_no_pullup: SCL is used in a non-compliant way and has no pull-up. * Therefore disable open-drain. */ struct i2c_gpio_platform_data { int udelay; int timeout; unsigned int sda_is_open_drain:1; unsigned int sda_is_output_only:1; unsigned int sda_has_no_pullup:1; unsigned int scl_is_open_drain:1; unsigned int scl_is_output_only:1; unsigned int scl_has_no_pullup:1; }; #endif /* _LINUX_I2C_GPIO_H */